Basic Tron Set = 2 X 1m EL Wire + 2 X EL Tape Hoops + Driver – Neon Glow Costume

With this set you get:

1) 2 pieces of 1metres high quality (3.2mm) Electro- Luminescent  Wire

2) 2 X EL Tape Hoops - 6cm in diameter 

3) Decent 4XAAA battery Driver/Inverter with on/off switch plus 4 modes including continuous ON, Strobe, Slow blink and Fast Blink

4) 4 way splitter to make the whole The splitter lets you have 3 X 1metre lengths of EL Wire  attached to one driver/inverter - This gives you greater control and flexibility in the designs of your tron costume

The EL Wire can be any combination of these colours:

Aqua (Tron Blue), White, Red, Orange, Purple, Pink and Yellow

To make it easier to design your outfit, below are the dimensions of the inverters and lengths of connecting wires - there is also tips on how to create your costume 

DRIVER/INVERTER

The Power Pack takes 4 X AAA batteries an has a built in voltage inverter that 'inverts' the 6Volts from the batteries up to the 100Volts needed to make the EL Wire glow

The power pack/inverter is 8.5cm X 5cm X 2cm

It has an On/Off switch - plus a mode button for the 4 Modes: Continuous, Strobe, Fast Blink and Slow Blink

It has an 8cm wire coming out of it that leads to the...

SPLITTER

The Splitter is 40cm long in total,

it is 20cm of wire which then splits into 4 separate strands which are all 20cm long and lead to the...

EL WIRE

There is then another 20-25cm from the connector until the actual glowing start of EL Wire - then there is 2 X 1metres of gorgeous glowing wire!

These are long enough to run up the body and down the arm

EL HOOPS

The other part of the splitter runs to two 6cm diameter EL Hoops that make any Tron costume look amazing

Its not complicated or fiddly - ive just given all those details if you want to plan your costume before you buy the set

The whole kit is ready to use - just plug and play!

OR FEEL FREE TO CONTACT US IF YOU WANT HELP WITH YOUR EL PROJECT